Allow Spotipo servers through your UniFi firewall
🔹 Applies to: UDM, UDM-Pro, UXG-Pro, and similar UniFi Security Gateways.
The following IP addresses must be allowed through all firewalls on your network to ensure Spotipo can connect properly. This guide details firewall setup for UniFi devices only, but the same rules apply to any other firewall in use.
Under Firewall Rules, press Create New Rule
Go to Settings > Firewall and Security.
Under Firewall Rules, click Create New Rule.
Configure the rule:
Type: Internet Local
Description: spotipo_allow
Action: Accept
IPv4 Protocol: All
Destination IP & Port Group: Any
Create a New Port/IP Group:
Name: Spotipo_servers
Add these IPs:
Finally save the Firewall rule and you should see something like below in your Firewall Rules
sing UniFi's Zone-Based Firewall?** Follow this guide
The following IP addresses must be allowed through all firewalls on your network to ensure Spotipo can connect properly. This guide details firewall setup for UniFi devices only, but the same rules apply to any other firewall in use.
Under Firewall Rules, press Create New Rule
**For UniFi Gateways (UDM, UXG, etc.)**
Go to Settings > Firewall and Security.
Under Firewall Rules, click Create New Rule.
Configure the rule:
Type: Internet Local
Description: spotipo_allow
Action: Accept
IPv4 Protocol: All
Destination IP & Port Group: Any
Create a New Port/IP Group:
Name: Spotipo_servers
Add these IPs:
107.178.247.148
35.244.104.229
35.236.87.84
104.155.46.61
Finally save the Firewall rule and you should see something like below in your Firewall Rules
sing UniFi's Zone-Based Firewall?** Follow this guideUpdated on: 27/05/2025
Thank you!